Clone Trooper Leather Belt Kit – Soft Parts – DIY

Parts for a leather built Clone Trooper Belt, this lightweight and durable approach makes assembling a belt much simpler and straightforward! The base belt only weighs about 8 oz.

The belt utilizes a 60″ leather base with magnetic fasteners to secure the belt boxes in place. Blocks on the boxes prevent them from spinning or rotating. A 3/4″ leather punch will be necessary to cut holes for where you want your belt boxes to go. A center line is drawn on the belt to help with belt box placement. ONLY THE CENTER 8 HOLES ARE PRE-PUNCHED. The magnetic fasteners MUST be pointed upwards for the best results. 12 sets of magnetic fasteners are included but will need glued in place.

The belt includes a tab to connect the back sides but is left un-connected for custom fitting – if you decide to shorten the belt. The ends are connected by 2 clips on the thermal detonator.

The magnetic fasteners fit into pre-modeled holes featured in the Belt V5 files here: https://bit.ly/3V8um6D

The belt boxes can be included as raw 3d prints, they are not sanded/smoothed/painted. The front 2 large boxes are able to open and are hollow inside! 2 versions of a rear belt box are included, one for RotS and one for Battlefront 2.

Different colors are available as well. The leather is colored with a leather dye and includes care instructions to preserve the finish.

Magnetic fasteners are a SNAP Small Sewable Male and Female combo.

2 rubber casted sets of ridges are included in the selected color. 

Please allow 2-3 weeks to complete the order once placed as each is made to order.