Battlefront 2 EMP Launcher – DIY

Raw 3D Printed Parts for the EMP Launcher as seen in the original Battlefront 2

Printed in durable PLA at a highly detailed .16mm layer height

The blaster itself is quite large so we cut a rod through the center for a 3/4″ (1″ outer diameter) hole for a PVC reinforcement pipe (not included)

You’ll need a pipe 38 1/4″ long for the roughly 44″ total length blaster. It features stand-ins for the wire so you can easily incorporate actual wires into the prop.

Please allow 2-3 weeks processing time as each launcher is made to order. Printed in whatever filament we have on hand – usually gray